On Sat, Nov 25, 2017 at 4:45 PM, Bill Somerville <g4...@classdesign.com>
wrote:
> Hi OM,
>
>>
>> Hi, Bill,
> I suspect there is a problem with the reliability of your audio
> connections to your rig. How is your rig connected to your PC for audio?
Bluetooth low energy via a Rigblaster Blue. This morning the waterfall
stopped after two transmits.
> Make sure you do not have "Settings->Radio->Allow Tx frequency changes
> while transmitting" checked as that is not possible with the Yaesu
> FT-817/857/897(D) series of rigs.
>
>
Verified that "Allow TX frequency changes while transmitting" is NOT
checked. (Never has been.) This morning I changed the Rigblaster delay to
minimum. No change
in behavior. I note that the poll interval is automatically set to 1 second.
A recap, this problem manifested itself with the advent of WSJT-X 1.7.0,
with a USB direct link. I was using a Rigblaster Advantage at the time.
> If you are using some form of VOX, particularly the SignaLink USB for
> audio then reduce any VOX delay to the minimum. It can also help to switch
> to CAT PTT rather than VOX, even with the SignaLink USB.
>
Tried CAT PTT and the rig switched to transmit. Had to power it off and
back on to recover it.
Thanks for the suggestions, but no change.
73 de KH6CP, Craig.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
