Hi Tony, > Using a 2.2.x version, decoding on a busy band has the following behavior: > first decode in cycle picks up a few messages, second decode a few, then the > third decode runs a long time (well into the next cycle) and the majority of > messages get decoded on that third decode.
What are your typical DT values, i.e. what is the median DT value for a cycle that has a good number of decodes? Normally, we expect to see the bulk of the decodes produced by the first decoding segment (say, 80%) and only a small number of decodes produced during the third segment. However, if there is significant receiver latency, this can push most of the decodes into the third segment. FWIW, no decoding is done during the second decode segment. This segment is used to subtract all of the decodes that were obtained during the first segment. Steve k9an
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
