On 2020-06-09 10:21 a.m., Tony wrote:
Hi Bill –
The 2.1.x versions of wsjt-x decoding works well, both fast and normal decode.
The fast decode is a little quicker on 2.1.x, but both can be used without an
issue.
Using a 2.2.x version, decoding on a busy band has the following behavior:
first decode in cycle picks up a few messages, second decode a few, then the
third decode runs a long time (well into the next cycle) and the majority of
messages get decoded on that third decode.
Switching between fast and slow does not help, since the poor decode is already
unusable with the fast decode, so hard to tell if normal is much slower.
Radio being used is Yaeusu FT-991. Same problem reported by others using the
FT-991A, FT-867D, and TS-590SG. See (https://groups.io/g/RigPi/topic/74694393).
Thanks for your reply,
AE0AU - Tony
I have made a couple of screen recordings to help describe the issue.
First 2.1.2
https://youtu.be/MF8sPvode9c
then
2.2.1
https://youtu.be/x89NKQqLxU4
Sometimes it is not too bad but it does seem the longer it runs the
worse it gets.
73
Glenn VE9GJ
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
