I am going to start trying to see if I can figure out what is not getting set.
By the way. This board also has 4 other serial ports on a 8250.c driver. It also fails under the xeno build. On 3/20/12 4:35 PM, "Gilles Chanteperdrix" <gilles.chanteperd...@xenomai.org> wrote: > On 03/20/2012 09:19 PM, Glen Wernersbach wrote: >> I actually think in is in the settings because if run just the setup part of >> the code without reading and writing, on the kernel that works my activity >> LED turns off. >> >> On the xeno kernel the LED never changes. > > I actually think that CONFIG_XENO_OPT_PERVASIVE does not make any > difference which could cause a difference of hardware behaviour. So, it > must be another option triggered by this config change. So, if you want > us to help you, please post the .configs. > -- Glen Wernersbach President & CTO Jetsoft Development Co. 629 Old St Rt. 74 Suite 210 Cincinnati, Oh 45244 Custom Programming Web Site: www.jetsoftdev.com Retail Products Web Site: www.scanhelp.com Phone: 513-528-6660 Fax: 513-528-3470 Cell 513-240-9929 ---- Partner for Software Technology Jacobs Automation 2365 Progress Drive Hebron, KY 41048 (513) 297-7550 ---- "Support Dyslexia Research" _______________________________________________ Xenomai-help mailing list Xenomai-help@gna.org https://mail.gna.org/listinfo/xenomai-help