So if you can tell the hello world program is transferred to the remote target successfully, I'm assuming that you can access the remote target. So on it, can you grep the running process and see whether there's tcf-agent?
-----Original Message----- From: emirelkh...@gmail.com [mailto:emirelkh...@gmail.com] Sent: Tuesday, May 22, 2012 1:37 PM To: Zhang, Jessica Cc: yocto@yoctoproject.org Subject: Re: [yocto] Connecting to target using eclipse/ADT Hello, I can ping my target with no problem, and when I tried to debug a hello world program it transferred the hello world file the target. The connection just timed out so I was unable to debug through eclipse. How can I check to verify the tcf agent is running on thr target? Do you have instructions? Thanks, Emir On May 22, 2012, at 4:23 PM, "Zhang, Jessica" <jessica.zh...@intel.com> wrote: > So do you have access to your target at all? Can you verify that the > tcf-agent is up running on the target device? > > -----Original Message----- > From: yocto-boun...@yoctoproject.org [mailto:yocto-boun...@yoctoproject.org] > On Behalf Of Emir Elkholy > Sent: Tuesday, May 22, 2012 11:58 AM > To: yocto@yoctoproject.org > Subject: [yocto] Connecting to target using eclipse/ADT > > When connecting to my CRB that is running off a usb drive that has yocto on > it I am trying to connect to the CRB from my host in order to debug using TCF > agent. Through eclipse I am entering the IP address of the target, and > attempting to debug from the debug configurations menu. Using a simple > helloworld as an example, the file is actually transferred to the target CRB, > but the debugging fails. Eclipse gives me a connection timing out error (not > allowing me to debug). Is there a link that describes how to connect to a > physical target using eclipse and the ADT? Is there anything that must be > done on the target side first before attempting to debug? I only enter the IP > address of the target under debug configurations, I don't setup anything on > the target side, maybe this is the problem? I followed the same procedure as > connecting to the QEMU (which works) as I did with the physical hardware. I > can't find anything online about a connection time out either. > > Thanks > _______________________________________________ > yocto mailing list > yocto@yoctoproject.org > https://lists.yoctoproject.org/listinfo/yocto _______________________________________________ yocto mailing list yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/yocto
