Emirelkholy, If the program is successfully transferred to the target by the Eclipse then I assume the tcf-agent is already running. However please doublecheck the followings: - When you create connections, make sure you choose type TCF. - Try to goto "Remote system explorer(RSE) perspective", and see if you can open a terminal to your target through tcf - make sure gdbserver is installed on your target
Best Regards, -Lianhao emirelkh...@gmail.com wrote on 2012-05-23: > Hello, > I can ping my target with no problem, and when I tried to debug a hello world > program it transferred the hello world file the target. The > connection just timed out so I was unable to debug through eclipse. How can I > check to verify the tcf agent is running on thr target? Do you > have instructions? > > Thanks, > Emir > > > > On May 22, 2012, at 4:23 PM, "Zhang, Jessica" <jessica.zh...@intel.com> wrote: > >> So do you have access to your target at all? Can you verify that the >> tcf-agent is up running on the target device? >> >> -----Original Message----- >> From: yocto-boun...@yoctoproject.org [mailto:yocto-boun...@yoctoproject.org] >> On Behalf Of Emir Elkholy >> Sent: Tuesday, May 22, 2012 11:58 AM >> To: yocto@yoctoproject.org >> Subject: [yocto] Connecting to target using eclipse/ADT >> >> When connecting to my CRB that is running off a usb drive that has yocto on >> it I am trying to connect to the CRB from my host in order to > debug using TCF agent. Through eclipse I am entering the IP address of the > target, and attempting to debug from the debug configurations > menu. Using a simple helloworld as an example, the file is actually > transferred to the target CRB, but the debugging fails. Eclipse gives me a > connection timing out error (not allowing me to debug). Is there a link that > describes how to connect to a physical target using eclipse and > the ADT? Is there anything that must be done on the target side first before > attempting to debug? I only enter the IP address of the target > under debug configurations, I don't setup anything on the target side, maybe > this is the problem? I followed the same procedure as > connecting to the QEMU (which works) as I did with the physical hardware. I > can't find anything online about a connection time out either. >> _______________________________________________ yocto mailing list yocto@yoctoproject.org https://lists.yoctoproject.org/listinfo/yocto