I don't know, I don't have any CMMs. We had a micro a long time ago and
it blew up two days after install so we never used another one. I just
remembered that timing port to timing port had to be roll-over, x-over,
whatever you want to call it. You can probably poke around in the GUI
and figure it out.
On 10/6/2014 4:00 PM, Paul McCall via Af wrote:
And then it just magically �works� somehow? No definition of which
one is slave and master etc. ?
*From:*Af [mailto:af-boun...@afmug.com] *On Behalf Of *George Skorup
(Cyber Broadcasting) via Af
*Sent:* Monday, October 06, 2014 4:54 PM
*To:* af@afmug.com
*Subject:* Re: [AFMUG] how to use (2) CMM Micro and one GPS antenna ??
IIRC, it needs to be a roll-over cable. Pin 1 to 6 and 2 to 3. 2 & 3
if you care about the GPS data, otherwise just 1 to 6 and 6 to 1.
On 10/6/2014 3:48 PM, Paul McCall via Af wrote:
I have to hook up a CMM to a tower that already has a CMM on it,
like today.�� There is a �timing� 6 pin connector on the
CMM.� Can that be used to bridge the sync to the 2^nd CMM?� If
so, how would that be wired, and what setting would I make in the
CMM(s) so that it would know to use it
�
Paul
�
Paul McCall, Pres.
PDMNet / Florida Broadband
658 Old Dixie Highway
Vero Beach, FL 32962
772-564-6800 office
772-473-0352 cell
www.pdmnet.com <http://www.pdmnet.com/>
pa...@pdmnet.net <mailto:pa...@pdmnet.net>
�
