I actually had to use this tool on a site tonight. I used the new Ethernet Upgrade Tool for windows, was directly connected to the Ethernet port on my laptop. I pressed 'yeah I have read the blah blah blah' and then hit discover, it told me to reboot. I disconnected power 1 and 2 for a sec and when I plugged it back in it gave me the IP. Then I couldn't figure out the SNMP so I had to use it again to reset, same process. It worked perfectly both times.
On Mon, Nov 24, 2014 at 7:28 AM, Josh Luthman via Af <[email protected]> wrote: > Not sure what email address to use offlist... > > I've done all that several times to confirm. I also went straight to the > NIC as well as trying a Netgear dumb switch (it had link light, doesn't > specify speed/duplex). > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > On Mon, Nov 24, 2014 at 3:33 AM, Forrest Christian (List Account) via Af < > [email protected]> wrote: > >> Unfortunately there's quite a few things which will break the tool. I've >> attached a .pdf which should cover all of them. Make sure you have the >> right tool as described, and if you have problems afterwards let me know. >> >> -forrest >> > >
