Re: [AFMUG] -48 PDU suggestions

[Adam Moffett]

I'm pretty sure mine were reading the correct voltages until after the 
software update.  Now the 24v input reads 46, and the 48v input reads 61.

Hardware or software? Hopefully these can be fixed in software because 
I need to get them deployed. Does this mean the overcurrent protection 
won't work right either? These are going to be a long drive away and I 
don't want to have them not working right and have to go fix them.

I'm remembering something... The two new PDUs came with the latest 
firmware, but I did have to update the 2-relay / 3-switch modules and 
the older PDU module. Not sure if the old PDU shows the 35 volts now 
with the updated firmware. I can check again tomorrow.

On 8/18/2015 6:51 PM, Forrest Christian (List Account) wrote:

I've heard twice now weirdness with that voltage reading.    Both in 
the last week.   I haven't had a chance to get it on the bench to test.

I'm guessing that I'm reading the wrong adc input somehow.

On Aug 18, 2015 4:00 PM, "George Skorup" <geo...@cbcast.com 
<mailto:geo...@cbcast.com>> wrote:

    Not to get off topic here, but the two 5ch PDUs I just got show
    35.5-ish volts on the master input... with no supply connected.
    And the status LED doesn't flash like it normally would if it
    sees no/low voltage on the master. Seems strange. Are these bad
    or should I just not worry about it? They were both showing that
    before and after I updated the firmware, BTW. I only have one
    other one from months ago for a mockup that I never ended up
    using and it acts normally. It shows like 1.2 volts on the input
    with nothing feeding it and the status LED does flash 5 or 6 times.