No RADIUS, just bridge. I do have interference, but it is generally minimal. No smart meters, very rural, usually a low noise floor.
I'm going to be swapping a bunch of this hardware out in 3-4 weeks, but I need to buy some time. I suppose I was hoping the 13.4.1 had some issue and a downgrade would fix all my problems. On Wed, Jul 6, 2016 at 6:43 PM, Sean Heskett <af...@zirkel.us> wrote: > Are you using RADIUS? We had to turn auth off for several 900 APs because > the connection was too weak to maintain the tunnel necessary for the RADIUS > handshake. > > Sounds like you probably have interference which is typical for 900mhz > > -Sean > > > On Wednesday, July 6, 2016, Christopher Gray <cg...@graytechsoftware.com> > wrote: > >> It is not especially scientific at this point. Customers who claim they >> previously had no problem now have regular re-registrations. I'm starting >> to wonder if some of these radios are simply failing [one is receiving >> around -70 dBm but cannot keep a link up long enough to get the spectrum >> analyzer to work]. >> >> This is a network that I started working on a little to quickly. I knew a >> bunch of links were not stable on 2X modulation and there had been no >> firmware updates, so went straight into "fixing" all of the firmware. >> >> Perhaps I should be asking about good settings for high interference >> situations? >> >> If 13.4.1 is not lacking, I'll keep it there and dig into other options. >> >> -Chris >> >> >> On Wed, Jul 6, 2016 at 10:41 AM, Brandon Yuchasz <li...@gogebicrange.net> >> wrote: >> >>> Chris in the interest of muddying the waters more and contradicting what >>> Sean just said. We also are using 13.4.1 on all APs since we were >>> collocating with 450i. Its been very stable for us as well and I did not >>> notice any week signal connections becoming worse. The contradiction is we >>> did not upgrade SM firmware. Most are still on 10.5. I know we should but >>> many are being replaced by epmp or 450i. maybe you should define a week >>> connection. >>> >>> >>> >>> Best regards, >>> >>> Brandon Yuchasz >>> >>> GogebicRange.net >>> >>> www.gogebicrange.net >>> >>> >>> >>> *From:* Af [mailto:af-boun...@afmug.com] *On Behalf Of *Christopher Gray >>> *Sent:* Wednesday, July 06, 2016 4:03 AM >>> *To:* af@afmug.com >>> *Subject:* [AFMUG] PMP100 900MHz Best Firmware? >>> >>> >>> >>> I upgraded a system that had a mix of firmware ranging 7.x to 12.x. I >>> moved everything to 13.4.1. >>> >>> >>> >>> I'm seeing stability issues. Weak links or high interference links are >>> dropping regularly where they were not dropping in the past. Decent links >>> appear to be holding 2X modulation better, but I need to keep the weaker >>> links up. >>> >>> >>> >>> Is there a consensus or at least good recommendation regarding the most >>> stable firmware for the 900MHz PMP100? >>> >>> >>> >>> Thank you - Chris >>> >> >>