I've had an open ticket about the AF-2X for over a month. I have not been
able to actually work with anyone on the issue. It has been "escalated" but
without any positive results.

Is there a better way to talk to someone about the airFiber?

The spec sheet says a US AF-2X has a maximum Tx power of 30 dBm... but it
only goes up to 24 dBm. [I'm running an 18 dBi dish on one end with long
cables, and I need the additional 3 dB Tx power). When changing channel
width, the Rx power does not change (Rx power is usually measured in
dBm/20Hz on most UBNT hardware, so power usually goes up 3 dB when halving
the bandwidth, but I can't get a straight answer as to whether they use the
same units on the AF line).

Long story short, I'm going to have to get rid of this AF-2X hardware and
switch back to ePMP. The AF-2X would be the better choice if I could get
the power levels I need to make this link work. I would much rather solve
the AF problems..

-Chris

Reply via email to