Is this in FCC area?  FCC rules for 2.4 GHz PTP are 30 dBm max transmitter 
power with 6 dBi antenna, for a total +36 dBm EIRP.  Then for antenna gain 
above 6 dBi, you have to reduce xmt power 1 dB for every additional 3 dB of 
antenna gain.  Also this is independent of channel width, it’s not dBm/MHz.

So you have an 18 dBi dish, that’s 12 dBi of additional antenna gain, so you 
would have to reduce xmt power by 1/3 of 12 dBi or 4 dB, to +26 dBm, and max 
EIRP would be +42 dBm.

How many dB do you figure you’re losing in the long cables?  I’m unclear on 
whether cable loss counts against xmt power or antenna gain.  If you’re losing 
several dB in the cable, I can see where you’d want the full +30 dBm xmt power 
from the radio.

From: Christopher Gray 
Sent: Friday, July 29, 2016 1:20 PM
To: [email protected] 
Subject: [AFMUG] UBNT AF-2X Problems... Where Do You Go For Help?

I've had an open ticket about the AF-2X for over a month. I have not been able 
to actually work with anyone on the issue. It has been "escalated" but without 
any positive results. 

Is there a better way to talk to someone about the airFiber?

The spec sheet says a US AF-2X has a maximum Tx power of 30 dBm... but it only 
goes up to 24 dBm. [I'm running an 18 dBi dish on one end with long cables, and 
I need the additional 3 dB Tx power). When changing channel width, the Rx power 
does not change (Rx power is usually measured in dBm/20Hz on most UBNT 
hardware, so power usually goes up 3 dB when halving the bandwidth, but I can't 
get a straight answer as to whether they use the same units on the AF line). 

Long story short, I'm going to have to get rid of this AF-2X hardware and 
switch back to ePMP. The AF-2X would be the better choice if I could get the 
power levels I need to make this link work. I would much rather solve the AF 
problems..

-Chris

Reply via email to