I don’t follow your math.

The most likely interpretation is that conducted power is at the antenna end of 
the cable, so if you have 1 dB of cable loss, you can increase radio xmt power 
1 dB to compensate.

The other interpretation would be that cable loss subtracts from antenna gain.  
So if you have 1 dB of cable loss, then in effect you have 1 dB less antenna 
gain, and can increase xmt power by 1/3 of a dB.

Oh, one more thing, make sure you aren’t getting caught in the difference 
between aggregate vs per stream power levels.  UBNT products are pretty clear 
about this in the GUI though.


From: Mathew Howard 
Sent: Friday, July 29, 2016 3:56 PM
To: af 
Subject: Re: [AFMUG] UBNT AF-2X Problems... Where Do You Go For Help?

I'm pretty sure that you could increase transmit power to compensate for cable 
loss, which would mean you'd only need 1db of cable loss to be able to up the 
transmit power by 3db... and anything that's being called "long cables" is 
almost certainly going to be more than 1db.


On Fri, Jul 29, 2016 at 2:27 PM, Ken Hohhof <[email protected]> wrote:

  Is this in FCC area?  FCC rules for 2.4 GHz PTP are 30 dBm max transmitter 
power with 6 dBi antenna, for a total +36 dBm EIRP.  Then for antenna gain 
above 6 dBi, you have to reduce xmt power 1 dB for every additional 3 dB of 
antenna gain.  Also this is independent of channel width, it’s not dBm/MHz.

  So you have an 18 dBi dish, that’s 12 dBi of additional antenna gain, so you 
would have to reduce xmt power by 1/3 of 12 dBi or 4 dB, to +26 dBm, and max 
EIRP would be +42 dBm.

  How many dB do you figure you’re losing in the long cables?  I’m unclear on 
whether cable loss counts against xmt power or antenna gain.  If you’re losing 
several dB in the cable, I can see where you’d want the full +30 dBm xmt power 
from the radio.

  From: Christopher Gray 
  Sent: Friday, July 29, 2016 1:20 PM
  To: [email protected] 
  Subject: [AFMUG] UBNT AF-2X Problems... Where Do You Go For Help?

  I've had an open ticket about the AF-2X for over a month. I have not been 
able to actually work with anyone on the issue. It has been "escalated" but 
without any positive results. 

  Is there a better way to talk to someone about the airFiber?

  The spec sheet says a US AF-2X has a maximum Tx power of 30 dBm... but it 
only goes up to 24 dBm. [I'm running an 18 dBi dish on one end with long 
cables, and I need the additional 3 dB Tx power). When changing channel width, 
the Rx power does not change (Rx power is usually measured in dBm/20Hz on most 
UBNT hardware, so power usually goes up 3 dB when halving the bandwidth, but I 
can't get a straight answer as to whether they use the same units on the AF 
line). 

  Long story short, I'm going to have to get rid of this AF-2X hardware and 
switch back to ePMP. The AF-2X would be the better choice if I could get the 
power levels I need to make this link work. I would much rather solve the AF 
problems..

  -Chris


Reply via email to