While running from R1 to R4 (maxing at only 10 Mbps), I can also run from R1 to R3 an additional 15+.
Also, while running from R1 to R4 (again, maxing at 10 Mbps), I can also run from R3 to R4 an additional 60+. Aggregation on the M5 link is defaulted to 32 frames / 50,000 bytes. Could this be causing such issues on a good link? On Wed, Oct 26, 2016 at 2:54 PM, Christopher Gray < [email protected]> wrote: > R1 is the only router with 1 Gbps ports. Everything is auto except 1 > connection that requires manual settings. > > *R1* -- (Auto 1 G FD) ...Internet... (Manual 100 FD) -- *R2 *-- (Auto 100 > FD) -- *R3* -- (Auto 100 FD) ...M5... (Auto 100 FD) -- *R4* > > MTU is set to 1500 on every port (and the UBNT link). > > Flow control is off, and none of the interfaces show any pause frames > received. > > > This is a live link, but it is only running ~ 1 Mbps otherwise. > > > > On Wed, Oct 26, 2016 at 2:12 PM, Steve <[email protected]> wrote: > >> Few questions come to mind. >> >> Are all set to auto negotiate or are they fixed at 100Mbit? >> What are the MTU's of each connection? >> Flow control turned on? >> >> >> ----- Original Message ----- >> From: "Christopher Gray" <[email protected]> >> To: "af" <[email protected]> >> Sent: Wednesday, October 26, 2016 1:57:56 PM >> Subject: [AFMUG] Trouble Identifying Throughput Issue >> >> I have a section of my network that is lacking something, and I can't >> figure out where the problem is. I'm looking for any thoughts / >> suggestions. >> >> 4x MikroTik routers >> >> Link speeds: >> R1 -- (30 Mbps IP / Transport) -- R2 -- (100 Mbps Eth) -- R3 -- (75 Mbps >> UBNT M5) -- R4 >> >> The limiting factor for traffic should be the Transport, and I expect to >> be >> able to get 30 Mbps across the system (one-way). >> >> Testing from R1 to R3 runs 30 Mbps. >> >> Testing from R2 to R4 runs 75 Mbps. >> >> Testing from R1 to R4 only runs 10 Mbps (instead of 30). >> >> Tests were one-way btest with 20 TCP streams. >> >> Any ideas for something that would cause this? >> > >
