> Not 100% impossible. It's worked for us if the master PTP450 is co-located > with the PMP450 APs. We set the DL % to the same (we're using 65% DL where > we're doing this). > > The big problem is the auto-ranging that the PTP450 does, and there's not > much you can do about it. Once it's synced up, if you've set the framing > properly, they will sync just fine. > > Many people on the list have asked for, like, forever to have a way to "set" > the framing parameters so that this would be easier.
Back with the backhaul 20's transmit frame spreading used to help a lot with the issue. I would think having a setting to cap range would be easy for cambium to do since they are based on an AP anyway. > The other problem since the beginning of time with Canopy style PTPs is that > the master starts up in beaconing mode with a max range of like 120 miles > and waits for a BHS reg attempt then does auto-ranging and shifts the > timing. So yeah, it's pretty much impossible. > > On 10/27/2016 3:18 PM, Sean Heskett wrote: > > that's been true since the beginning of time. > > you can get it close with 50% downlink on the AP and then use the frame > calculator to match the air delay parameter to the BHS. not easy at all but > you could probably get it to work. > > your best bet is to use different bands for PMP and PTP tho. > > -Sean > > > On Thu, Oct 27, 2016 at 12:37 PM, Jon Langeler <[email protected]> > wrote: >> >> I don't think their support department understands the concept of sync. >> But as of now we have given up on PTP products syncing 100% with PMP >> products. Oh well >> >> Jon Langeler >> Michwave Technologies, Inc. >> > > >
