Put a paper clip in the N connectors, extend it about 7mm above the end of the connector and give it a 45 degree slant. One slant one way, the other slant the opposite.
From: Jaime Solorza Sent: Thursday, July 13, 2017 8:40 AM To: Animal Farm Subject: Re: [AFMUG] AirFiber 5 connectorized Yes I enabled power back off...okay...thanks Jaime Solorza On Jul 13, 2017 8:28 AM, "Colin Stanners" <cstann...@gmail.com> wrote: No antennas connected? I hope you turned tx power way down, else the food may not have been the only thing frying in that kitchen. Signal strength LEDs activate only when you are quite close to expected signal level so don't rely on them too much. On Thu, Jul 13, 2017 at 9:24 AM, Jaime Solorza <losguyswirel...@gmail.com> wrote: I configured 2 AF5s last evening for installation later today. I was able access the remote radio and ping across with no issues from kitchen table to counter. I had no antennas or GPS connected. I never saw the LEDs for signal strength light up. These are the first units I have ever configured. Do I need to do anything to activate them? Tak Jaime Solorza