Installed an AC M5 with Omni and three PowerBeam 30s instead at some well sites. Couldn't get to backhaul site where AF are going due to construction..
Jaime Solorza On Jul 13, 2017 4:36 PM, <ch...@wbmfg.com> wrote: > Was thinking N connectors. > > *From:* Mathew Howard > *Sent:* Thursday, July 13, 2017 4:23 PM > *To:* af > *Subject:* Re: [AFMUG] AirFiber 5 connectorized > > 5x have RP-SMA connectors... a paper clip won't fit in the hole... well, > there isn't even a hole, since it's RP... > > I just keep a couple of antennas off old routers on the bench for that > kind of thing. > > On Thu, Jul 13, 2017 at 10:02 AM, Chuck McCown <ch...@wbmfg.com> wrote: > >> Yes, 5x >> >> *From:* Kurt Fankhauser >> *Sent:* Thursday, July 13, 2017 9:00 AM >> *To:* af@afmug.com >> *Subject:* Re: [AFMUG] AirFiber 5 connectorized >> >> you talking about an AF5X? Cause the original AF5 I didn't know had a >> connectorized version, integrated only. >> >> On Thu, Jul 13, 2017 at 10:53 AM, Chuck McCown <ch...@wbmfg.com> wrote: >> >>> Put a paper clip in the N connectors, extend it about 7mm above the end >>> of the connector and give it a 45 degree slant. One slant one way, the >>> other slant the opposite. >>> >>> *From:* Jaime Solorza >>> *Sent:* Thursday, July 13, 2017 8:40 AM >>> *To:* Animal Farm >>> *Subject:* Re: [AFMUG] AirFiber 5 connectorized >>> >>> Yes I enabled power back off...okay...thanks >>> >>> Jaime Solorza >>> >>> On Jul 13, 2017 8:28 AM, "Colin Stanners" <cstann...@gmail.com> wrote: >>> >>>> No antennas connected? I hope you turned tx power way down, else the >>>> food may not have been the only thing frying in that kitchen. >>>> >>>> Signal strength LEDs activate only when you are quite close to expected >>>> signal level so don't rely on them too much. >>>> >>>> On Thu, Jul 13, 2017 at 9:24 AM, Jaime Solorza < >>>> losguyswirel...@gmail.com> wrote: >>>> >>>>> I configured 2 AF5s last evening for installation later today. I was >>>>> able access the remote radio and ping across with no issues from kitchen >>>>> table to counter. I had no antennas or GPS connected. I never saw the >>>>> LEDs for signal strength light up. These are the first units I have ever >>>>> configured. Do I need to do anything to activate them? Tak >>>>> >>>>> Jaime Solorza >>>>> >>>> >>>> >>> >> > >
