yes, the only gain in using the upc is you can adjust rod length to tilt a mast to plumb left to right take into account i rarely mount to tower legs, i mount to old grain legs, the angle iron upright is rarely plumb plus MTOW costs alot more, otherwise all i would use is MTOW, i dont have trust in UPC so i limit the load more than i would with mtow
On Thu, Apr 19, 2018 at 2:46 PM, <ch...@wbmfg.com> wrote: > OK, so again, you do realize I have a whole product line for angle iron, > right? > > *From:* Steve Jones > *Sent:* Thursday, April 19, 2018 1:43 PM > *To:* af@afmug.com > *Subject:* Re: [AFMUG] MTOW clamps > > no, this is for mounting to angle iron. I put a pipe inside for clamp grip > > On Thu, Apr 19, 2018 at 2:41 PM, <ch...@wbmfg.com> wrote: > >> So you are adding an piece of angle iron to a round tower leg? >> I presume y’all know about these: >> https://www.mccowntech.com/product-category/tower-mounts-acc >> essories/angle-iron-tower-leg-mounting-accessories/ >> >> *From:* Steve Jones >> *Sent:* Thursday, April 19, 2018 1:37 PM >> *To:* af@afmug.com >> *Subject:* Re: [AFMUG] MTOW clamps >> >> >> >> >> On Thu, Apr 19, 2018 at 9:54 AM, <ch...@wbmfg.com> wrote: >> >>> The M-TOW-P-48 is not an angle iron part. If that is what you ordered >>> that is not what got shipped. >>> >>> -----Original Message----- From: Seth Mattinen >>> Sent: Wednesday, April 18, 2018 8:24 PM >>> To: af@afmug.com >>> Subject: Re: [AFMUG] MTOW clamps >>> >>> On 4/18/18 7:16 PM, Chuck McCown wrote: >>> >>>> The M-TOW products that are made for angle iron tower legs have a flat >>>> back clamp. But the others are still the curved clamp. We could have had >>>> a packing error in final assembly I suppose. >>>> >>> >>> >>> Oh, then I got the wrong one, I've never seen the angle iron tower ones. >>> Ordered from Streakwave. M-TOW-P-48 >>> >> >> > >
