|
This may or may not work due to timings slips that you
may experiance with the Digium Cards. Your are correct in assuming this
scenaro.
I did the same (pre-asterisk) with an Adtran
Atlas. It is rock solid and works great. What modem access bank are
you using, there has been some talk about using the PM3 as an IAX gateway.
(highly vaporware at this point), The Acend unit support SIP, the Cisco
suport..., etc. etc,
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Adam Vocks Sent: Wednesday, June 01, 2005 11:07 AM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: [Asterisk-Users] Pass-through In an order to save money, I would
like to use a PRI that we have going to one of our dial-up modem banks (We are
an ISP.) During business hours these channels are idle and during our peak
internet times, we are closed. Sounds too good to be true, but I thought I
would throw it out there. These are modem calls that if they would call
our modem bank number, they would be bridged to the outbound zap
channels??? And of course, if they dial our business number we would send
them to the appropriate sip channels. I didn’t know if this could be done
with two T1 cards and asterisk… Here is a primitive
sketch.
If anyone has information, please
share. Thank
You Adam
Vocks CTI |
_______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
