On Fri, 14 Nov 2008 20:57:22 +0200, Maxim Levitsky wrote > Bob Copeland wrote: > > On Wed, Nov 12, 2008 at 07:51:47PM +0200, Maxim Levitsky wrote: > >>>> Why it doesn't accept new mac?, can this be fixed? > >> Any update on mac changer status? > > > > As a first stab, can you try this patch? This sets the address on > > Works almost perfectly, > > when I load the module, then run macchanger, and then ifconfig wlan0 up > then it works, if I do an ifconfig up once, then ifdowning the interface, it > doesn't.
Yeah, I had actually written more for that patch originally, but didn't post it because it was a bit more invasive. I think the issue is just that start() shouldn't program the mac at all and let add_interface handle that. I'll post a revised patch in a day or two. > The noise floor calibration issue bites me again and gain. > When it shows up, usually card continues to work, but at next assotiation > stops working. Does this help? http://marc.info/?l=linux-wireless&m=122570806813839&w=2 > Transfer speeds are unusually low: You can try using the minstrel rate control algorithm, it may help. -- Bob Copeland %% www.bobcopeland.com _______________________________________________ ath5k-devel mailing list ath5k-devel@lists.ath5k.org https://lists.ath5k.org/mailman/listinfo/ath5k-devel