Hi Victor, I strongly recommend using Xilinx's 14.7 release. Some people use Ubuntu 12.04 -- see https://casper.berkeley.edu/wiki/MSSGE_Setup_with_Xilinx_14.x_and_Matlab_2012b -- but as Dan says, life might be easier with a supported operating system...
Cheers, Jack On Tue, 23 Jun 2015 at 13:01 Dan Werthimer <d...@ssl.berkeley.edu> wrote: > > > hi victor, > > i urge people to only use operating systems supported by xilinx: > i think right now, that means > windows7 pro, redhat enterprise linux 5 or 6, or suse enterprise linux. > > several casperites have tried to use non-supported linux operating systems > for casper work. > sometimes this can work fine for particular appliciations, sometimes it > doesn't work. > > xilinx will not provide any support or answer any questions if you use a > non-supported operating system. and we've seen be subtle bugs > without any reported error messages with a non-supported operating system. > one time we found the casper FFT didn't work for sizes over 2^13 points - > there was no > error message - it just computed the FFT incorrectly on the FPGA - the > simulation > worked fine... when we switched to redhat, the problem went away... > > best wishes, > > dan > > > > > On Tue, Jun 23, 2015 at 12:48 PM, Victor Cardoso < > victorcardoso...@hotmail.com> wrote: > >> Greetings, >> >> I am working with the ROACH 2 in order to implement the MUSIC project. I >> am having a lot of troubles to compile the Tutorial 1 (Introduction to >> Simulink) due to mismatch between Xilinx ISE 14.5 and my Operating System, >> Ubuntu 10.04. >> I would like to know if it's possible to run this example using Ubuntu. >> Otherwise, I can install Redhat Enterprise Linux 6.3, Matlab 12b and Xilinx >> 14.5 to run the codes. >> >> I look forward hearing from you. >> >> Best Regards, >> Victor Cardoso. >> > >
