Can we see the interface configs? No peer neighbor route or something like that?
If you use hdlc on each link instead of ppp can you ping then? Cheers, Matt Sent from my iPad On 11/06/2010, at 16:29, Patrice Ngassam <[email protected]> wrote: Hi there, I tried Volume 2 - Lab3 using GNS3 and I am getting weird output. I configured MLPPP between R6 and R9 but they could not ping each other: *R6>sh ip int br Interface IP-Address OK? Method Status Protocol FastEthernet0/0 unassigned YES NVRAM up up Serial0/0 110.99.46.6 YES NVRAM up up FastEthernet0/1 unassigned YES NVRAM up up Serial0/1 unassigned YES NVRAM up up Serial0/2 unassigned YES NVRAM up up Serial0/3 unassigned YES NVRAM administratively down down Multilink1 110.99.96.6 YES NVRAM up up R6>ping 110.99.96.5 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 110.99.96.5, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) R6>sh ip route 110.99.96.6 % Subnet not in table R6>sh ip route 110.99.46.6 Routing entry for 110.99.46.0/27 Known via "connected", distance 0, metric 0 (connected, via interface) Routing Descriptor Blocks: * directly connected, via Serial0/0 Route metric is 0, traffic share count is 1* R6> Same output on R9: *R9>sh ip int br Interface IP-Address OK? Method Status Protocol FastEthernet0/0 unassigned YES NVRAM up up Serial0/0 unassigned YES NVRAM up down FastEthernet0/1 unassigned YES NVRAM up up Serial0/1 unassigned YES NVRAM up up Serial0/2 unassigned YES NVRAM up up Serial0/3 unassigned YES NVRAM administratively down down Multilink1 110.99.96.5 YES NVRAM up up R9>ping 110.99.96.6 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 110.99.96.6, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) R9>sh ip route 110.99.96.5 % Network not in table R9>* I could not find what's wrong ! *Patrice Ngassam CEO NEN NET Inc.* ------------------------------ From: [email protected] To: [email protected] Date: Fri, 11 Jun 2010 00:37:50 -0400 Subject: Re: [OSL | CCIE_RS] Do I put my wic-1&2t's in slot 0 or slot 1? I used slot 1 and 2 to enable the configs to work better. This allows for faster pasting of configs. This is the area that seems to slow down the most...prepping my lab for the study module. ------------------------------ De nouvelles Emoticones sur Messenger ? Téléchargez les Emoticones pâte à modeler !<http://www.ilovemessenger.fr/emoticones/emoticones-pate-a-modeler.aspx> _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
