Ahhh... sorry i missed it. you are right steve...
thanks On Wed, Oct 20, 2010 at 9:51 PM, Di Bias, Steve <[email protected]>wrote: > On R4 you are showing > > > > frame-relay map ip 150.100.24.4 402 broadcast > > > > It should be frame-relay map ip 150.100.24.2 402 broadcast > > > > Thank you, > > > > Steve Di Bias > > Network Engineer - Information Systems > > *Valley Health System – Las Vegas* > > *Office* - 702- 369-7594 > > *Cell* - 702-241-1801 > > *[email protected]* <[email protected]> > > > ------------------------------ > > *From:* [email protected] [mailto: > [email protected]] *On Behalf Of *Amer Mustafa > *Sent:* Wednesday, October 20, 2010 11:41 AM > *To:* [email protected] > *Subject:* [OSL | CCIE_RS] Weird issue facing. > > > > *Weird issue facing , OSPF neighborship is up between R4 and R2, though i > cant ping R2 from R4. below are the configuratons on the interfaces , can > anyone adivse why is that ?* > > > > R2 : > > > > interface Serial0/1/0 > description Frame Relay Links > no ip address > encapsulation frame-relay > no arp frame-relay > no frame-relay inverse-arp > frame-relay lmi-type cisco > ! > interface Serial0/1/0.24 point-to-point > description Frame Relay Cloud 2 > bandwidth 64 > ip address 150.100.24.2 255.255.255.0 > frame-relay interface-dlci 204 > > > > R4 : > > > > ! > interface Serial0/0/0 > bandwidth 64 > ip address 150.100.24.4 255.255.255.0 > ip nat enable > encapsulation frame-relay > ip ospf network point-to-point > no arp frame-relay > frame-relay map ip 150.100.24.4 402 broadcast > no frame-relay inverse-arp > frame-relay lmi-type cisco > end > > > > ========== > > on R4 : > > > > R4(config)#do sospfn > > Neighbor ID Pri State Dead Time Address Interface > 200.0.0.2 0 FULL/ - 00:00:39 150.100.24.2 > Serial0/0/0 > > > > ------------- > > on R4 : > > > > R4#ping 150.100.24.2 > > Type escape sequence to abort. > Sending 5, 100-byte ICMP Echos to 150.100.24.2, timeout is 2 seconds: > ..... > Success rate is 0 percent (0/5) > > > > > > > > UHS Confidentiality Notice: This e-mail message, including any attachments, > is for the sole use of the intended recipient(s) and may contain > confidential and privileged information. Any unauthorized review, use, > disclosure or distribution of this information is prohibited, and may be > punishable by law. If this was sent to you in error, please notify the > sender by reply e-mail and destroy all copies of the original message.
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com
