Do sh int switchport | b Fa0/23 <--output for ports 23 and 24 show run int Fa0/23 show run int Fa0/24 sh int trunk | i Port|Fa0/2[34] show etherchan summary
On Sun, Nov 20, 2011 at 8:54 PM, marc abel <[email protected]> wrote: > I have two dynamic desirable trunks configured as an ether-channel and > one keeps un-bundling > > Nov 20 19:49:06.347: %EC-5-CANNOT_BUNDLE2: Fa0/23 is not compatible > with Fa0/24 and will be suspended (trunk mode of Fa0/23 is access, > Fa0/24 is trunk) > Nov 20 19:49:07.335: %LINEPROTO-5-UPDOWN: Line protocol on Interface > FastEthernet0/23, changed state to down > > > It then comes back up and everything seems fine for a bit and then it > happens again. Any idea what the issue could be or how to > troubleshoot? Obviously I could configure them as statically trunking > but a lab requirement prevents this. > > Thank you, > > Marc > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > To Unsubscribe from this list please visit the following link and follow > the directions to unsubscribe. > http://onlinestudylist.com/mailman/listinfo/ccie_rs > -- -- Olugbenga Oyebande MD, DAIT 234-803-302-5287 http://www.dait-ng.com Cisco Unified Network, VPN DAIT Enterprise Network Servers Broadband Internet Deployment & ISP Consultancy _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com To Unsubscribe from this list please visit the following link and follow the directions to unsubscribe. http://onlinestudylist.com/mailman/listinfo/ccie_rs
