Cat1 is passive on Tu0. Bob -- Sent from my iPhone, please excuse any typos.
On Mar 18, 2012, at 8:00 AM, khaled al-ajeman <[email protected]> wrote: > hi guys, > > my CAT1 AND R6 are not forming neighborship between each other? > > cat1 > > router ospf 1 > router-id 10.10.11.11 > log-adjacency-changes > passive-interface default > no passive-interface FastEthernet0/0 > network 10.10.10.10 0.0.0.0 area 111 > network 111.111.111.111 0.0.0.0 area 111 > interface Tunnel0 > ip address 10.10.10.10 255.255.255.0 > tunnel source 150.100.113.111 > tunnel destination 150.100.113.6 > > R6 > > R6(config)#do sh run int tunnel0 > Building configuration... > Current configuration : 127 bytes > ! > interface Tunnel0 > ip address 10.10.10.6 255.255.255.0 > tunnel source 150.100.113.6 > tunnel destination 150.100.113.111 > end > R6#sh run | s os > hostname R6 > ip ospf cost 4713 > ip ospf network non-broadcast > ip ospf priority 0 > router ospf 1 > router-id 10.10.6.6 > log-adjacency-changes > network 10.10.6.6 0.0.0.0 area 0 > network 10.10.10.6 0.0.0.0 area 111 > network 150.100.100.6 0.0.0.0 area 0 > network 150.100.169.0 0.0.0.255 area 69 > regards, > > khaled > _______________________________________________ > For more information regarding industry leading CCIE Lab training, please > visit www.ipexpert.com > > Are you a CCNP or CCIE and looking for a job? Check out > www.PlatinumPlacement.com > > http://onlinestudylist.com/mailman/listinfo/ccie_rs _______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com http://onlinestudylist.com/mailman/listinfo/ccie_rs
