by the way my understanding is that in the real LAB the RDNIS does not work today - you would need VM-Integration option to be configured to get it work properly in your real lab. I know at home I made it to work with redirected number option.
On 2/15/08, jason sung <[EMAIL PROTECTED]> wrote: > > Juan, > > You may have already done this, Is the RDNIS box checked on the HQ PRI? > > > On Feb 15, 2008 2:28 PM, Juan Lopez Hernandez -X (jlopezhe - IBM - INS at > Cisco) <[EMAIL PROTECTED]> wrote: > > > Hello, > > > > I need some help as I can't figure out the following: I try to test > > Unity with BR1 in SRST. All is going fine, the call to unity is set up over > > PSTN, redirecting number works fine. From the CCM trace files I see the call > > coming in as: > > > > SETUP pd = 8 callref = 0x00AB > > Bearer Capability i = 0x8090A3 > > Channel ID i = 0xA98381 > > Calling Party Number i = '!', 0x80, '6175252001' > > Called Party Number i = 0x80, '2122251600' <------- 4 last digits are > > the Unity pilot number - this incoming number gets stripped to ''1600'' > > Redirecting Number i = 0x000082, '6175252002' > > > > When looking into Unity's Call Viewer, I notice that the ''dialed > > number'' always follows the ''forwarding number''. So instead of seeing the > > number 1600 as dialed number in the Call Viewer , I see whatever is the > > forwarding number. Is there a setting that can be changed so you see the > > correct ''dialed number''? > > > > Kind regards, > > Juan > > > > > > > > > > -- Ovais Iqbal 416-294-7869