No Roger No voice features are supported on this Network Module. It does tie in to any DSP resources to be able to support voice and has no onboard DSPs capable of supporting voice.
Regards - Basant On Tue, Feb 24, 2009 at 8:34 PM, Rogers O. OCHIENG <r.ochi...@smoothtel.com>wrote: > Hi, > > > > I have the NM-2CE1T1-PRI card, i was wondering if this can be used for > voice as i’m not getting the port when i try specifying the port in pots > dial-peer > > > > I configured : > > ! > > Isdn switchtype primary-net5 > > ! > > voice type e1 2/0 > > ! > > controller e1 2/0 > > pri-group timeslots 1-31 > > no crc-4 > > no shut > > ! > > Interface serial 2/0:15 > > Isdn incoming-voice voice > > Isdn overlap-receiving > > No shut > > ! > > Dial-peer voice 1 pots > > Destination-p 2....... > > Port 2/0:15 > > ^ > > Unrecorgnized command > > > > > > *From:* ccie_voice-boun...@onlinestudylist.com [mailto: > ccie_voice-boun...@onlinestudylist.com] *On Behalf Of *Cliff McGlamry > *Sent:* 24 February 2009 22:18 > *To:* ccie_voice@onlinestudylist.com > *Subject:* [OSL | CCIE_Voice] Time management strategies > > > > I'm curious about how others are planning their time for the labs. > > > > In reading through the lab, it seems to me that it is best to go through > and do all the drawings, dial plan design, etc. at the beginning. This > means you might be spending a bit more time on it, but in my experience, an > hour spent planning generally saves two or more. > > > > I'd be interested to know if other folks are doing their dial plan table at > the same time they do their drawing of the network, or what. > > > > Cliff > > >
