I noticed this and I believe it is a typo further evidenced by the note next to
the command that says something to the effect that that command moves it to q1t1
Sent from my iPhone
On Oct 20, 2012, at 2:17 AM, "Pixar Perfect" <pixarperf...@live.com> wrote:
> The requirement is as follows on Lab 2 QOS section of the 5-Lab Handbook.
> "For traffic being sent to the Site A gateway ensure that the traffic marked
> with COS 5 is dropped if the queue 1 is 75% full"
>
> The Solution guide (page 408) has the following solution.
>
> mls qos queue-set output 2 threshold 1 75 100 100 100 --> queset is
> preconfigured on the port to 2
> mls qos srr-queue output cos-map queue 1 threshold 3 5
>
> ..
> My interpretation was to move the Cos 5 into Q1t1 but the command says
> threshold 3 .. is this just a typo or am I missing something obvious.
>
>
> Thanks!
> _______________________________________________
> For more information regarding industry leading CCIE Lab training, please
> visit www.ipexpert.com
>
> Are you a CCNP or CCIE and looking for a job? Check out
> www.PlatinumPlacement.com
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
