steffen,
your approach is not right way of doing it because when u look the threshold
values of the queues you have allocated max threshold is 100 and reserved
threshold is 100, guess what both threshold i.e. t1 and t2 takes up to 100%
value when desired and that being said after t1 and t2 were filled it comes to
t3 which has 75% i.e. it is the last threshold where it will take/borrow the
memory value from reserved threshold when desired. long story short... right
way of doing it either assign it to t2 or t1 and assign threshold value of 75%
for correct approach...
thank you
krishna.
________________________________
From: Steffen Bruening <stbruen...@gmail.com>
To: Pixar Perfect <pixarperf...@live.com>
Cc: ccie_voice@onlinestudylist.com
Sent: Saturday, October 20, 2012 6:38 PM
Subject: Re: [OSL | CCIE_Voice] LAN Qos questions
I have this seen this also, to be honest I think it shouldn't matter whether it
is in threshold 1 or 3 as long as no other COS is in same Threshold of queue 1
of queset 2. When you leave in in threshold 3 I think you should be fine with:
mls qos queue-set output 2 threshold 1 100 10075 100.
Maybe I am completly wrong but thats they way I understood this.
Regards
Steffen
2012/10/20 Pixar Perfect <pixarperf...@live.com>
The requirement is as follows on Lab 2 QOS section of the 5-Lab Handbook.
>"For traffic being sent to the Site A gateway ensure that the traffic marked
>with COS 5 is dropped if the queue 1 is 75% full"
>
>
>The Solution guide (page 408) has the following solution.
>
>
>mls qos queue-set output 2 threshold 1 75 100 100 100 --> queset is
>preconfigured on the port to 2
>mls qos srr-queue output cos-map queue 1 threshold 3 5
>
>
>..
>My interpretation was to move the Cos 5 into Q1t1 but the command says
>threshold 3 .. is this just a typo or am I missing something obvious.
>
>
>
>
>Thanks!
>_______________________________________________
>For more information regarding industry leading CCIE Lab training, please
>visit www.ipexpert.com
>
>Are you a CCNP or CCIE and looking for a job? Check out
>www.PlatinumPlacement.com
>
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com
_______________________________________________
For more information regarding industry leading CCIE Lab training, please visit
www.ipexpert.com
Are you a CCNP or CCIE and looking for a job? Check out
www.PlatinumPlacement.com