Indeed, I missed this. I know that configuration issues generally prevent calls with Not Enough Bandwidth error, and your calls are completing, referring to your earlier email.
Even then, can you share your physical serial interface and subinterface configs on both sides? On Mon, Apr 1, 2013 at 8:57 PM, Saeed IDris <saee...@gmail.com> wrote: > > Thanks Suresh, i think you didn't see my last update which sent by Email: > > check it pls: > > Thanks for your quick reply kindly check the below info: > > for Location its already configured as following: > > for HQ: relation to HQ= no Reservation > > and for HQ: relation to Br1= Mandatory > > for Br1: relation to Br1= no Reservation > > and for BR1: relation to HQ = Mandatory > > MRGL HQ: (applied for HQ_DP) > > MTP_G729 (VGW-HQ) > > HW_Codec (VGW-HQ) > > HW_Conf (VGW-HQ) > > MRGL BR1: (applied for BR1_DP) > > MTP_G729 (VGW-BR1) > > HW_Codec (VGW-BR1) > > HW_Conf (VGW-BR1) > > > HQ_Phone1 (5001) location HQ_Loc (applied via HQ_DP) > > BR1_Phone1 (1001) location BR1_Loc (applied via BR1_DP) > > HQ_VGW configured with HQ Device pool > > BR1_VGW configured with BR1 Device pool > > hopefully it clear. > > > > Regards, > > Saeed > > On Mon, Apr 1, 2013 at 6:07 PM, Suresh Bhandari <bring...@gmail.com>wrote: > >> Can you make sure that your calling and called gateways and phones are in >> different Locations? And further, have you set the bandwidth reservation >> requirement between your intended locations is set to "Mandatory"? >> >> If your calling and called phones are not is expected Locations, and no >> "Mandatory" reservation is there, then no rsvp is involved. >> >> Check and make tests. >> >> HTH >> >> >> On Mon, Apr 1, 2013 at 7:26 PM, Saeed IDris <saee...@gmail.com> wrote: >> >>> Greeting Experts, >>> >>> I need your assistance for RSVP LAB 10 Vol-1 I have configured MTP >>> ,location and added MTP on CUCM ...and its register working fine plus i >>> have added IP RSVP bandwidth commend under sub-interface of frame relay >>> link on >>> both Gateway HQ and BR1 (RSVP over Frame Relay) the issue that RSVP is >>> not trigger even if i call (VOIP) between the two different location >>> after i changed the IP RSVP bandwidth to less than 24k but still i can >>> initiate more than three calls even i run the debug for both gateway I >>> can't see any info related to RSVP packet from both Gateway. >>> >>> what is the missing on my configuration ? >>> >>> Regards, >>> >>> Saeed >>> >>> _______________________________________________ >>> For more information regarding industry leading CCIE Lab training, >>> please visit www.ipexpert.com >>> >>> Are you a CCNP or CCIE and looking for a job? Check out >>> www.PlatinumPlacement.com >>> >> >> >> >> -- >> Suresh Bhandari >> > > -- Suresh Bhandari
_______________________________________________ For more information regarding industry leading CCIE Lab training, please visit www.ipexpert.com Are you a CCNP or CCIE and looking for a job? Check out www.PlatinumPlacement.com
