Thanks a lot Bill, got your mail with the drawing as well
it was exactly what I tried to explain (while re-reading I didn’t understand myself that’s why I tried to be more precise) Thanks ! Med Vennlig Hilsen/Kind Regards/Cordiali Saluti André Broe Jensen -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Bill Lessenberry Sent: 11. januar 2004 03:26 To: The Chevelle Mailing List Subject: RE: [Chevelle-list] Need two measurement of off a 1968 Chevelle At 06:01 PM 1/10/2004, you wrote: >Thanks a lot Bill, > >:o) > >Just one thing, I don't know if I explained well, did you take the >measurement at the edge between where the front molding ends and where >the rear molding begins or did you start at the rear molding edge going >straight forward ?? I measured from the actual fender opening, the edges of the sheet metal, using the moldings as reference points. This meant that the tape measure was sloping down from front to back. I'll try to draw something here: ______________________ / \ front / \ molding ======/ \ rear / \ ============ molding \ I hope this makes sense :-)) BL
