Hmm... I am writing from (long term) memory here... I can't test it right now, but what most likely has to be done is to build 2 different vservers, and use the "vlan <num>" classifier (with a different vlan ID per vserver). Both vservers can use the same servergroup...
Saying that, I am quite positive I made it work a couple of years back, but since then the config was migrated to CSM, so I am not anymore Arie -----Original Message----- From: Robert Blayzor [mailto:[EMAIL PROTECTED] Sent: Wednesday, July 11, 2007 19:45 PM To: Arie Vayner (avayner) Cc: Paul Stewart; [email protected] Subject: Re: [c-nsp] SLB Question Arie Vayner (avayner) wrote: > If you really need to be able to provide access to the VIP from the > same > L2 domain where the real servers are located, I would recommend moving > to dispatched mode. > Just disable "nat server", and configure the VIP as a loopback > interface on the real servers (easily done on any OS). This would > allow the servers to use the VIP as a source, so both remote and local > clients would be able to access the VIP on the SLB instance, but the > return traffic would not require a translation back... That's news to me. I remember according to the docs even when using dispatch mode, a layer3 hop is still required. I've tried endless times to get L2 adjacent hosts to use virtual server addresses on the same subnet/l2 with no luck. Even in dispatch mode I don't think the router will re-write the mac in the packets unless it traverses a L3 hop. Correct me if I'm wrong and point me to the documentation that proves this please. -Robert _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
