Lukas Garberg wrote:
Hi all,
while configuring an OSPF process for a VRF on a Cisco 3550-12G
(running 12.2(25)SE) I notice that the command "passive-interface"
is unavailable. How can this be? Is there another way I can suppress
routing updates on an interface?
You can put actual network commands in ospf configuration section. For
example:
network 172.16.8.1 0.0.0.0
network 172.17.0.30 0.0.0.0
network 172.17.0.242 0.0.0.0
It will activate interfaces in the target VRF only. You can redistribute
any other routes you need to announce.
WBR
Roman A. Nozdrin
Relevant parts of the configuration:
!
ip vrf SAN
rd 29468:1
!
interface Loopback1
ip vrf forwarding SAN
ip address 172.17.0.242 255.255.255.255
!
interface Vlan390
ip vrf forwarding SAN
ip address 172.17.0.30 255.255.255.252
! interface Vlan391
ip vrf forwarding SAN
ip address 172.16.8.1 255.255.252.0
! router ospf 64512 vrf SAN
log-adjacency-changes
auto-cost reference-bandwidth 10000
capability vrf-lite
area 0 authentication message-digest
network 172.16.0.0 0.15.255.255 area 0
!
Regards,
Lukas Garberg
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
