I was attempting something similar, several months back. I received confirmation from TAC that PLAR is currently not supported with the ATA190. Again, this was back in November of last year. I can’t say whether or not this has been addressed/corrected since then. But my case notes state that I basically had to pound sand on that request…..
- J From: cisco-voip [mailto:[email protected]] On Behalf Of Barry Howser Sent: Friday, March 13, 2015 12:30 PM To: [email protected] Subject: [cisco-voip] ATA190 Plar SIP Dial Rule Hello everyone. I have an ATA190 that needs to do a plar to 911. My dial plan uses "9" to access an outside line (including the 911 pattern). I created a SIP dial rule and added a plar pattern. I added a parameter called "911" in the description and then added 9911 in the value field. I saved, applied config and restarted. I have applied that SIP Dial Rule to the ATA190 device's sip dial rule section and reset the ATA. When I take either of the lines off hook with an analog phone, I just get dial tone .... no PLARing. What am I doing wrong? thanks
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
