So I have tried it with the 190 and the 187 so far and WITHOUT a SIP dial rule and just a SCCP PLAR config I just get tone. When I add in a SIP dial rule (configured with a button parameter of either 1 or 2) I get dial tone for a few seconds, then dumps to a fast busy. I know the SCCP plar portion is working because if I apply it to a SCCP phone or an ATA186, works just great.
My CUCM version is 8.6 so I had to add the device pack for the ATA190, but still, I haven't seen any referenced docs that state it doesn't work. I think I am going to try the TAC route. I'll let everyone know what comes of it. On Fri, Mar 13, 2015 at 3:50 PM, James Avalos <[email protected]> wrote: > I was attempting something similar, several months back. I received > confirmation from TAC that PLAR is currently not supported with the ATA190. > > Again, this was back in November of last year. I can’t say whether or not > this has been addressed/corrected since then. But my case notes state that > I basically had to pound sand on that request….. > > > > - J > > > > *From:* cisco-voip [mailto:[email protected]] *On Behalf > Of *Barry Howser > *Sent:* Friday, March 13, 2015 12:30 PM > *To:* [email protected] > *Subject:* [cisco-voip] ATA190 Plar SIP Dial Rule > > > > Hello everyone. > > I have an ATA190 that needs to do a plar to 911. My dial plan uses "9" to > access an outside line (including the 911 pattern). > > I created a SIP dial rule and added a plar pattern. I added a parameter > called "911" in the description and then added 9911 in the value field. I > saved, applied config and restarted. > > I have applied that SIP Dial Rule to the ATA190 device's sip dial rule > section and reset the ATA. When I take either of the lines off hook with an > analog phone, I just get dial tone .... no PLARing. > > What am I doing wrong? > > thanks >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
