Brian, I have attached the screen shot of the sip dial rule.
I have the ATA187 using the same CSS on the device and line. That CSS only accesses one partition. That partition has one translation pattern, with a "blank" pattern field and the digits 9911 in the "Called Party Transformation" field. The translation pattern uses a CSS that has access to a 9.911 route pattern (pattern discards predot). thanks On Fri, Mar 13, 2015 at 4:58 PM, Brian Meade <[email protected]> wrote: > Sorry, it was the ATA187s I tried this on. Can you attach a screenshot of > your dial rule config? > > On Fri, Mar 13, 2015 at 4:15 PM, Brian Meade <[email protected]> wrote: > >> Right, that's correct. Add 2 PLARs to the SIP Dial Rule with >> descriptions both with just a button parameter. >> >> I've used this for ATA 188s but haven't tested specifically on the 190. >> >> On Fri, Mar 13, 2015 at 3:46 PM, Barry Howser <[email protected]> >> wrote: >> >>> hi Brian, >>> >>> So what you're saying is that in the SIP dial rule; I'll click the "Add >>> Plar" button and then give my parameter a description, select "Button" as >>> my dial parameter then in the value box I'd enter a "1" or a "2" depending >>> on if I wanted the *PLAR* working on line 1 or 2 of the ATA. >>> >>> I would then assume that if I wanted both ATA lines to plar, I would >>> have two parameters in the SIP dial rule? >>> >>> Oyyyy ..... I wish you would write Cisco docs .... I can understand you, >>> lol. >>> >>> >>> On Fri, Mar 13, 2015 at 3:38 PM, Brian Meade <[email protected]> wrote: >>> >>>> For the SIP Dial Rule, all you want it to have is a PLAR with Button 1 >>>> set. Don't enter the number you want to PLAR to. Then just set up PLAR >>>> like you would for a SCCP phone with a new CSS/partition/blank translation >>>> pattern. >>>> >>>> On Fri, Mar 13, 2015 at 3:30 PM, Barry Howser <[email protected]> >>>> wrote: >>>> >>>>> Hello everyone. >>>>> >>>>> I have an ATA190 that needs to do a plar to 911. My dial plan uses "9" >>>>> to access an outside line (including the 911 pattern). >>>>> >>>>> I created a SIP dial rule and added a plar pattern. I added a >>>>> parameter called "911" in the description and then added 9911 in the value >>>>> field. I saved, applied config and restarted. >>>>> >>>>> I have applied that SIP Dial Rule to the ATA190 device's sip dial rule >>>>> section and reset the ATA. When I take either of the lines off hook with >>>>> an >>>>> analog phone, I just get dial tone .... no PLARing. >>>>> >>>>> What am I doing wrong? >>>>> >>>>> thanks >>>>> >>>>> _______________________________________________ >>>>> cisco-voip mailing list >>>>> [email protected] >>>>> https://puck.nether.net/mailman/listinfo/cisco-voip >>>>> >>>>> >>>> >>> >> >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
