I am also trying to setup using 3 routers (1 router configured as switch).
I am following the Hutnik's book. They recommend a configuration on
"serial0/0"... anybody could tell me what is serial0/0 ?
I can configure int s0, but not serial0/0.
Thanks,
Billy
""mikey"" <[EMAIL PROTECTED]> wrote in message
8g62gm$uf1$[EMAIL PROTECTED]">news:8g62gm$uf1$[EMAIL PROTECTED]...
> In order to do frame-relay with a back-to-back cable, one router must be
> configured as a switch - frame-relay switching (global-config) and the
> interface on the switch must be configured as a logical dce - frame-relay
> interf-type dce (int-config). When I have done it, i also had to map to
my
> local interface with frame-relay map in order to ping the local interface.
>
>
>
> "Vic Feferberg" <[EMAIL PROTECTED]> wrote in message
> 8g5ud7$kgj$[EMAIL PROTECTED]">news:8g5ud7$kgj$[EMAIL PROTECTED]...
> > I would like to setup frame relay back to back, but when I do what
> happens
> > is that the line protocol comes up and shortly after comes down again.
> >
> > Is it possible to set this up in a lab situation without a telco
> connection?
> >
> > TIA
> >
> >
> > ___________________________________
> > UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> > FAQ, list archives, and subscription info: http://www.groupstudy.com
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> > ---
>
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> ---
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
