Hi David,
This is an interesting problem. I do have a couple of questions about it:
1) Are you using trunking between the 6009 & the 3500's with VLANs?
2) Do you have VTP pruning turned on in the 6009?
The IOS-based Cisco switches have a nasty habit of not working with VTP
pruning, causing the 6009 to shut off VLANs to a switch. It's quite
possible this is what's happening.
Chris M.
----- Original Message -----
From: "David Jones" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Wednesday, August 02, 2000 11:01 AM
Subject: FastEtherchannel configuration
> Does anyone have any experience configuring FastEtherchannel on Cisco
> switches? I have two scenarios:
>
> Cisco 3524 ==== Cisco 6009 ===== Cisco 3524
> Running two xover cables to each 3524. When I configure what I believe to
> be correct on the 6000 and the 3500's assigning two ports each to the
> channel, I end up losing connectivity and have to remove the channel
config.
>
> Those switches are now in a production environment so for now, I have two
> 3524's, two xover's between them, trying to setup up the etherchannel. So
> far, I can't tell that I've been successful. Any suggestions or hints?
>
> Thanks,
>
> Dave
>
>
>
> <<David Jones.vcf>>
>
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
