I'd consider the 3005 at the remote sites. It has the capability to do a LAN-to-LAN NAT, where if you had customer A and customer B that both used 10.1.x you could map them to 45.1 and 45.2 respectively, or any other equal-mask network.
Fred Reimer - CCNA Eclipsys Corporation, 200 Ashford Center North, Atlanta, GA 30338 Phone: 404-847-5177 Cell: 770-490-3071 Pager: 888-260-2050 NOTICE; This email contains confidential or proprietary information which may be legally privileged. It is intended only for the named recipient(s). If an addressing or transmission error has misdirected the email, please notify the author by replying to this message. If you are not the named recipient, you are not authorized to use, disclose, distribute, copy, print or rely on this email, and should immediately delete it from your computer. -----Original Message----- From: Ryan Finnesey [mailto:[EMAIL PROTECTED] Sent: Saturday, August 09, 2003 10:36 PM To: [EMAIL PROTECTED] Subject: VPN Best Hardware to use? [7:73793] I need to setup VPNs to about 2000 sites. Each site will have an IDSL line installed that will be used to connect to monitor network devices and servers. Some of the remote networks will be using the same network block. I am looking to know what the best hardware to use on each end is. On my end, would it be better to use a PIX or a 3030? On the remote end, I was looking at a PIX 501, SOHO 91 or the 831? Thank you Ryan **Please support GroupStudy by purchasing from the GroupStudy Store: http://shop.groupstudy.com FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=73806&t=73793 -------------------------------------------------- **Please support GroupStudy by purchasing from the GroupStudy Store: http://shop.groupstudy.com FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html