Are your users using PPP? If they are look at the
command "no peer neighbor-route"
from Cisco CD:
The Cisco IOS software automatically creates neighbor
routes by default; that is, it automatically sets up a
route to the peer address on a point-to-point
interface
when the PPP IPCP negotiation is completed.
Hope this helps.....
William Swedberg CCNP CCDP
--- "C. Cubberley" <[EMAIL PROTECTED]> wrote:
> Hi,
>
> We are using Cisco AS5200's for our remote users
> to dial-in to our site.
> We have configured a local pool of ip addresses that
> they get assigned when
> they connect. (ip local pool as01 10.20.211.1
> 10.20.211.254).
> We are using EIGRP as the routing protocol, and when
> I show ip routes for
> one of the users, I see that they have a 32-bit
> subnet mask.
> (10.20.211.137/32 is directly connected, Async30).
> When they disconnect,
> the routing table believes it has to update this
> change. (I think.) Is
> there a way to specify a different subnet mask?
> I would like to reduce the incidences of routing
> updates from these devices.
> I think I am getting lost in EIGRP. Does anyone
> know if I am on the right
> track in following the way EIGRP works? (I have
> read the CISCO sites
> documentation, and been to the troubleshooting EIGRP
> presentation at
> networkers, but think I need to understand this
> better!)
>
> Thanks,
> Connie Cubberley
>
> ___________________________________
> UPDATED Posting Guidelines:
> http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to
> [EMAIL PROTECTED]
>
>
>
__________________________________________________
Do You Yahoo!?
Yahoo! Mail – Free email you can access from anywhere!
http://mail.yahoo.com/
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]