Re: ISL on sub-if

[whatshakin]

I just tried 12.0.3T3 Enterprise Plus and 12.0.4T IP Plus on a 2621 and neither version has an encapsulation command available under the interface config mode.  Both of these run on 8 flash and 32 Dram.  I finally found it on a 11.3 IP Plus IPSec 56 image which also requires 8 flash and 32 Dram.  I looked on the IOS software upgrade planner, the Software Compatibility Matrix and various IOS release notes looking for a feature set that is not so difficult to get (expensive) but none of them gave me any specifics to work with.  I am going to check the 12.0.4T version of IP Plus IPSec 56 ( 8flash/32dram) tomorrow just for the hell of it, and see whether that image has it (almost guaranteed). I will post the results.   ----- Original Message ----- From: Jared Carter To: [EMAIL PROTECTED] Sent: Saturday, September 02, 2000 9:28 AM Subject: ISL on sub-if Group-   I have 2 2924 and a 2620 I am trying to practice routing between VLANs.  The trunk between the switches is okay.  When I create the sub-if on the router and try to run encap isl 2, it barks at me that this is an unrecognized command... ie "encapsulation" is not a valid command.  I am running 12.0(3)T3 code on the router.  Am I just missing something obvious?   Thanks   /Jared