Yes, I have a pair of 2621s for redundancy and I am using hsrp. I'll turn
it off
and see if this warning message goes away. thanks..dj
----- Original Message -----
From: "Mark Vicuna" <[EMAIL PROTECTED]>
To: "D. J. Jones" <[EMAIL PROTECTED]>
Cc: <[EMAIL PROTECTED]>
Sent: Saturday, September 09, 2000 2:30 AM
Subject: Re: Vlan help required
> Is HSRP configured on the 2600?
>
> 2/3 on the 4000 is configured for vlan 1, but it looks like HSRP is
configured
> (for some reason) on the 2600 on a vlan (other than the management vlan)
which
> sits on the same segment as vlan 1.
>
> You don't need HSRP on a router stick design anyway.
>
> Hope this helps... just going by from the debug output..
>
> Mark.
>
>
>
>
>
> "D. J. Jones" <[EMAIL PROTECTED]> on 09/09/2000 15:34:18
>
> Please respond to "D. J. Jones" <[EMAIL PROTECTED]>
>
> To: [EMAIL PROTECTED]
> cc: (bcc: Mark Vicuna/Sydney/CDM)
>
> Subject: Vlan help required
>
>
>
> I'm trying to set up a one arm router (2621) to do some intervlan routing
> using subinterfaces which I have attached to a 4003 switch. I keep
getting
> these errors:
>
> %SYS-4-P2_WARN: 1/Tag 500 on packet
> from 00:00:0c:07:ac:02 port 2/3, but port's native vlan is 1
>
>
> Anyone have any ideas??..dj
>
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
>
>
>
>
>
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
