Try putting Portfast on the switch ports. Then reset the priorities on the
two routers, and re-enable HSRP. See if that helps
Bryan
"D. J. Jones" <[EMAIL PROTECTED]> wrote in message
01cf01c01a6a$f69f1450$[EMAIL PROTECTED]">news:01cf01c01a6a$f69f1450$[EMAIL PROTECTED]...
> Yes, I have a pair of 2621s for redundancy and I am using hsrp. I'll turn
> it off
> and see if this warning message goes away. thanks..dj
> ----- Original Message -----
> From: "Mark Vicuna" <[EMAIL PROTECTED]>
> To: "D. J. Jones" <[EMAIL PROTECTED]>
> Cc: <[EMAIL PROTECTED]>
> Sent: Saturday, September 09, 2000 2:30 AM
> Subject: Re: Vlan help required
>
>
> > Is HSRP configured on the 2600?
> >
> > 2/3 on the 4000 is configured for vlan 1, but it looks like HSRP is
> configured
> > (for some reason) on the 2600 on a vlan (other than the management vlan)
> which
> > sits on the same segment as vlan 1.
> >
> > You don't need HSRP on a router stick design anyway.
> >
> > Hope this helps... just going by from the debug output..
> >
> > Mark.
> >
> >
> >
> >
> >
> > "D. J. Jones" <[EMAIL PROTECTED]> on 09/09/2000 15:34:18
> >
> > Please respond to "D. J. Jones" <[EMAIL PROTECTED]>
> >
> > To: [EMAIL PROTECTED]
> > cc: (bcc: Mark Vicuna/Sydney/CDM)
> >
> > Subject: Vlan help required
> >
> >
> >
> > I'm trying to set up a one arm router (2621) to do some intervlan
routing
> > using subinterfaces which I have attached to a 4003 switch. I keep
> getting
> > these errors:
> >
> > %SYS-4-P2_WARN: 1/Tag 500 on packet
> > from 00:00:0c:07:ac:02 port 2/3, but port's native vlan is 1
> >
> >
> > Anyone have any ideas??..dj
> >
> >
> > **NOTE: New CCNA/CCDA List has been formed. For more information go to
> > http://www.groupstudy.com/list/Associates.html
> > _________________________________
> > UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> > FAQ, list archives, and subscription info: http://www.groupstudy.com
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> >
> >
> >
> >
> >
> >
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
