You may want to set your switch speed to 10Mbits an match up your duplex
too.
Duck
----- Original Message -----
From: Lonnie Paschall <[EMAIL PROTECTED]>
Newsgroups: groupstudy.cisco
To: <[EMAIL PROTECTED]>
Sent: Monday, September 11, 2000 10:45 AM
Subject: Excessive collisions
> I have a 4500 with a two port Ethernet module. Each port on the module
> connects to a different 2924 switch and is in a different subnet. I keep
> getting excessive collisions on the Ethernet interfaces, no runts, no
> giants, no CRC errors, just collisions. Any thoughts? There is no command
to
> set the duplex or speed on the module.
>
> Thanks,
>
> Lonnie
>
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
