This really should be one of the simplest scenarios.
Unfortunately since it's so simple and its not working we need more info on
just what's going on.
As previously suggested, please post the configs of the routers, also for
completeness - post the "sh int e0" for both routers and for good measure
post the "sh cdp neigh" for each router.
Kevin Wigle
CCDP/CCNP............
----- Original Message -----
From: "ekundayo taiwo" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Cc: <[EMAIL PROTECTED]>
Sent: Wednesday, 20 September, 2000 11:02
> Hi, stuart,
>
> I think the best advice is to go and get a CCNA, book. Falling that you'll
need another router to be the DCE (which will act as your clocking device).
>
> However if each router is connected to a Hub then I would assume the the
default gateway on your node PC has not been configured to reach the e0
interface of either router
>
> Your routers themselve will not be able to communicate with each other
without a DCE Device
>
> Good Luck
>
> ----- Original Message -----
> From: "Stuart Laubstein" <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Wednesday, September 20, 2000 2:57 PM
> Subject: Connect two cisco with transceivers
>
>
> > I am trying to connect two cisco 2501's together using rj45 cables and a
hub
> > and transceivers in the AUI slots. Will this work, and if so what might
I be
> > doing wrong as they certainly will not telnet or ping each other. I have
set
> > ip's on both E/O interfaces and both trannsceivers show a link. Setup
looks
> > like this
> >
> > router1 E/0----transceiver--cable--hub--cable--tranceiver--E/0 router2
> >
> > both the cables are only 15 inches long and someone mentioned that maybe
> > they need to be longer. Should I be using some other kind of cable?
> >
> > thanks for any help
> >
> > stuart
>
>
> _____________________________________________________________
> Get email for your site ---> http://www.everyone.net
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
