I may your term "outside" confused here, but you cannot Telnet into a pix
(outside) unless you carve a whole in the firewall (allowing your IP to
Telnet through). The intended design is to pass through the firewall as
VPN/ encrypted traffic, to an approved IP for Telneting or to bring up
Terminal Emulation. We use either use servers or a 2500's planted inside.
In some cases (real world), we use a phone activated power supplies to bring
up an encryption modem. With this scenario, the connection only exists when
you enter a code after so many phone rings & the traffic is encrypted point
to point from the PIX's AUX.
Not sure if I hit the mark with your question ;-)
Phil
----- Original Message -----
From: "Administrator" <[EMAIL PROTECTED]>
To: "Administrator" <[EMAIL PROTECTED]>
Cc: <[EMAIL PROTECTED]>
Sent: Sunday, February 18, 2001 11:42 AM
Subject: RE: Telnet to PIX outside interface
>
>
>
>
>
> John,
> You can try to reverse telnet from your router's AUX port to the
> console port of the Pix.
> Step 1: find out the tty# of your AUX port on the router ( sh line aux 0
> )
> It is probably tty #1 ( on my 2620 it was tty#4 because it has 4 serial
> port 0-3 making AUX 0 tty #4)
> Step 2: Verify the AUX port on the router has the same baudrate,
> Stopbits, and so on as the console
> port of the PIX
> Step 3: Using a standard Cisco Console Rollover cable connect the Aux of
> Router to Console of PIX.
> Step 4: Telnet into the IP address of the router using TCP Port 200x
> where x=the tty# of the AUX port of router.
> (ie telnet 192.168.10.1:2004). I did this internally in my lab and it
> works, but when I get to work on Tuesday,I will
> verify it works externally, with our external router /PIX.
>
> I hope this helps
> Bill
>
> -----Original Message-----
> From: Jim Bond [mailto:[EMAIL PROTECTED]]
> Sent: Tuesday, February 13, 2001 7:02 PM
> To: [EMAIL PROTECTED]
> Subject: Telnet to PIX outside interface
>
>
> Hello,
>
> I've got a 3640 router and PIX, running IPSec in
> between. Everything works fine except I can't telnet
> from 3640 to PIX outside interface. Any idea?
>
> Thanks in advance.
>
>
> Jim
>
>
>
> __________________________________________________
> Do You Yahoo!?
> Get personalized email addresses from Yahoo! Mail - only $35
> a year! http://personal.mail.yahoo.com/
>
> _________________________________
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
