We have a problem with our 3660 router. We forgot the enable password and
need to start from scratch and recreate the passwords. The problem is, the
router has no Flash memory, so the router only boots into Rommon mode...I
don't believe these routers have bootflash, because you can't use the "boot
tftp" command without a BOOTLDR not set error. So even after we manualy
install the IOS via X-modem and it is run in NVRAM, it loads the startup
config in memory and that just brings us back to where we were before....A
router in which we have no enable password for. What are our options at this
point? Thank you.
- Rizzo
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
