I've done recovery on the 3600's a handful of times & I don't necessarily
welcome the situation, because ROMON has so few commands as compared to boot
mode. Let us know exactly where you left off... What do you see. This is
commonly done & it should not take to many post or say 20 minutes on the
phone with the TAC to get things going again...
Phil
----- Original Message -----
From: "Rizzo Damian" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, March 20, 2001 6:36 PM
Subject: Password recovery
>
> We have a problem with our 3660 router. We forgot the enable password and
> need to start from scratch and recreate the passwords. The problem is, the
> router has no Flash memory, so the router only boots into Rommon mode...I
> don't believe these routers have bootflash, because you can't use the
"boot
> tftp" command without a BOOTLDR not set error. So even after we manualy
> install the IOS via X-modem and it is run in NVRAM, it loads the startup
> config in memory and that just brings us back to where we were before....A
> router in which we have no enable password for. What are our options at
this
> point? Thank you.
>
>
>
> - Rizzo
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
