Tried different speeds as well w/no luck. Verified from the previous owner
that this was working at 9600 8N1 before he shipped.
Thanks for the reply.
""John Neiberger"" <[EMAIL PROTECTED]> wrote in message
sab8a9e1.049@fsutil01">news:sab8a9e1.049@fsutil01...
> Try changing the baud rate on your PC/laptop. The default is 9600, but
> the console port can be changed to use 4800, 2400, and 1200 by making
> modifications to the configuration register. If you can get it to work,
> start out by doing password recovery by changing the register to 0x2142
> and rebooting. This will set it to ignore NVRAM and also reset the
> console speed back to 9600. When you've finished the password recovery
> procedure, make sure to set the register back to 0x2102.
>
> HTH,
> John
>
> >>> "Shawn P Bolan" <[EMAIL PROTECTED]> 3/21/01 12:51:05 PM >>>
> I received a 2523 via a private purchase and am having problems making
> a
> console connection. The settings call for 8-N-2 (no flow control),
> which I
> am using. I am using HyperTerminal with a connector/cable that works
> with
> my other routers, but not this one. The power light is green, but no
> other
> indicators.
>
> Any ideas? Thank you.
>
>
> --
> Shawn P Bolan, MCSE/MCT, CCNA
> [EMAIL PROTECTED]
>
>
> _________________________________
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
