ok...i have been through this one.
my suggestion.
make sure you have an access list associated with dialer-group 1
and on the remote site.
put a static route on both sides one on remote to get out and one on central
to get you
to remote and advertise to your network with a hevier weight than the IGP
route
if you want to test connectivity make the static more preferable ....make
sure you have
a interesting traffic access list or it will not dial.
Shoaib Waqar wrote:
> I am getting trouble in ISDN bri link. I have a
> Central site Router 3640 with 12.1.8 IP/IPX plus IOS.
> the route has 4 port BRI module. The remote site is
> having 2503, all u know that it has 1 port BRI. remote
> site is running 11.2.1 version of IOS. The call is
> placed using simple DDR commands as:
>
> Cisco 3640 Router
> =================
> Int bri 2/0
> ip add 130.1.1.1 255.255.255.0
> encap ppp
> dialer idle-timeout 300
> dialer fast-idle 300
> dialer string xxxxxxxx
> dialer-group 1
>
> Remote site (2503):
> ===================
>
> Int bri 0
> ip add 130.1.1.2 255.255.255.0
> encap ppp
> dialer idle-timeout 300
> dialer fast-idle 300
>
> In this scenario, a/c to customer need, the central
> site is placing call.When the call has placed, and we
> see the debug output, it shows all the debug of ppp
> negotiations and ISDN events as correct, with the
> install route at the end. When i run 'show isdn
> status' it shows me all layers up with one active
> layer 3 call also. Also 'show isdn active' gives me
> successful call to remote site. So nothing seems to be
> wrong with config. THE problem is that after
> connectivity when i try to ping from central site the
> remote site ip address, it times out. I took the 'show
> ip route', and it gives me only connected routes but
> dont show me the remote LAN network address of each
> site which it should give as i m running EIGRP at both
> sites. The primary link is working correctly as i have
> an SCPC 128K link between the two sites as well and
> showing correct routes. The switch type in pakistan
> normally we use is basic-net3 (SIEMENS switch). Can
> anyone plzz help me, where is the issue?? i have tried
> everything, dialer profiles and all. but nothing seems
> to be working, i cant ping the other side thru BRI.
>
> Shoaib
> CCNP,MCSE
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Auctions - buy the things you want at great prices
> http://auctions.yahoo.com/
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=2851&t=2712
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
